Complete package incorporates safety and hot water controls. Saving on installation from simplified plumbing and electrical connections, no anode to maintain or replace fully factory tested for reliability. Fast recovery rates

Benefits Of Unvented

Mains pressure hot water for balanced supply to showers and mixers – no shower pump to consider

no cold feed cistern required

• No head problems
• Safe, economical performance
• No loft pipes to freeze up
• Flexible sitting of cylinder installation

UK MANUFACTURED AND TESTED

Pullin Evolution cylinders are manufactured in the UK in

an ISO 9001:2000 factory with each unit being pressure

tested to 15 bar to ensure maximum safety. All Pullin

Evolution units have integrated thermostatic controls and

thermal cut outs for both direct and indirect heating.

A factory fitted temperature and pressure relief valve

provides a further level of thermal safety.

 

INSTALLATION AND CONNECTIONS

In order to give easy access to the cylinder during

installation all of the plumbing and electrical connections

are located at the front of the unit. In addition the

electrical connections are made to an integrated wiring

centre which allows for a neater and simpler installation.

Plumbing connections are 22mm compression.

 

‘COIL IN COIL’ TECHNOLOGY – INDIRECT UNITS

The Pullin Evolution heat exchanger has a ‘coil in coil’

design which allows for a fast re-heat when water is

used. Situated at the base of the unit, the heat

exchanger ensures nearly all of the water is heated.

 

COLD WATER CONTROLS

Each unit is fitted with a cold-water control set which

Incorporates a pressure reducing valve and strainer,

expansion relief valve and check valve. By incorporating

three components into one installation time is reduced

and the flow rate is improved across a range of inlet

pressures.

 

GUARANTEE

Pullin Evolution units come with a 10-year parts

guarantee for the cylinder and 2 years parts guarantee

on the expansion vessel and all other valves and fittings.

 

SELECTION GUIDE

Property type Indirect model Direct model

Bedsit 100I or 120I 100D or 120D

1 or 2 bed with 1 bath or shower 150I 150D or 170D

3 bed with 1 bath or shower 150I or 170I 170D or 210D

4 bed with 1 bath or shower 170I or 210I 210D or 250D

2 or 3 bed with 2 baths or shower 210I 210D or 250D

4 or 5 bed with 2 baths or shower 210I or 250I 250D or 300D

4 or 5 bed with 3 baths or shower 250I or 300I 300D

Light commercial usage 250I or 300I 250D or 300D

 

Note:

All sizings calculated using BS6700

60 ltr hot water per bath

60 ltr hot water per shower

15 ltr hot water per sink

7 ltr hot water per basin

This selection chart is for guidance only. Hot water requirements will vary dependent on bath

size, usage patterns, etc.

 

 

Pullin Evolution Information Brochure